![]() I wanted four screws securing the cabinets, so I did two anchors. When trying to anchor objects to lath and plaster walls, typical plastic anchors wont work. The method involves nailing 1-inch wide strips of wooden lath to open wall studs and covering them with three layers of wet plaster. PS I did screw the cabinet bracket into studs, but they are 24" on center and I could only secure the 47" cabinet to two studs. Lath and plaster was a popular interior wall construction technique prior to the 1940s. DO NOT use the plastic toggle bolts in lath and plaster!ĭrop an extra dollar and get the metal toggle anchors! It would have saved me a huge pain in the ass. I tried expanding the hole a little bit and then the whole thing just fell into the wall. But I couldn't get the plastic piece into the hole that I drilled! The plastic catches on the wooden lath and refuses to go through even with a hammer (it flexes instead) or when guided with little screw drivers (no good). They function by expanding under the plaster. Molly (fastener) - Wikipedia can hold a lot of weight since they are sturdy and reliable. To prevent cracking and crumbling you’ll need to pre-drill holes for your screws, and you can start by taping down a strip of blue tape before drilling holes. The wings are supposed to expand as you screw into it. MOLLY BOLTS One of the best anchors for plaster walls is the molly bolt, a metal sleeve put into a hole drilled in the plaster. You drill a hole, fold up the plastic piece, and push it into the hole. 2 Safety Guidelines for Hanging Heavy Items. It's a plastic version of the toggle bolt. 1 Tools and Materials Needed to Hang Heavy Things on Lath and Plaster Walls. I tried the plastic insert with wings like this. ![]() DO NOT use the self-drilling plastic drywall anchors in lath and plaster! They don't work because they can't penetrate the lath boards behind the plaster. First I tried those self-drilling screw-in plastic drywall anchors. ![]() Lath and plaster ceiling removal can be a bit more work because of that or the wire mesh can help a little. The galvanized mesh is most probably used and in older houses, it can be some sort of old chicken wire mesh. I went through several other options before the toggle type finally worked. Ceilings are done in the same fashion as the walls. When you tighten the bolt, it pulls the wings against the back of the laths, creating a securely anchored bolt. The wings fold up as it enters the hole, and then they spring out on the other side. I finally managed to find an anchor that works in lath and plaster - it's called a toggle bolt or molly! It's a bolt that screws into a pair of spring-loaded metal "wings." You drill a hole in the wall and insert the bolt into the hole. Not only are the walls non-flat, but many conventional drywall anchors simply don't work. ![]() I bet many people here have had to deal with at least one lath and plaster wall if they have older houses. I want to share my recent experience with anchoring a cabinet on a lath and plaster wall. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |